swell device?

[DWBH]

Oh, the pick is attached to the circuit? Got it then.

IMO, it's a much better design than Boss's Slow Gear.

[Derringer]

oh yeah ... definitely

the trigger with the pick will be sooooo much more accurate

[solderman]

Report from the Bread Board

Fired it up and, after the usual "where did I go wrong" debugging the thing works like a charm. Really good swell and has quite a broad settings spectra for attack an decade so it's really flexible. Thank's to the "pick to ground" setup the precision is 100% all the time. The only ting is that when you hammer on or pull off you won't get a swell unless you ground your finger tips as well 

Best swell circut I've tested yet. 

http://www.dirk-hendrik.com/temp/dod_fx15.pdf

http://filters.muziq.be/model/dod/fx/fx15

[DWBH]

I've been trying to find one of these on ebay, but I never saw not even one popping up.

[edd29]

thanks alot guys! i hope you really like it .
pick is connected in between 100k and 220k. and the strings is already
connected to the ground.

[rousejeremy]

thanks alot guys! i hope you really like it .
pick is connected in between 100k and 220k. and the strings is already
connected to the ground.

Fantastic idea.

[edd29]

thanks alot guys! i hope you really like it .
pick is connected in between 100k and 220k. and the strings is already
connected to the ground.

Fantastic idea.

thanks man!

[solderman]

Hi All
Here's the "That's Swell" DOD FX 15 Clone.

I Just love the conductive pick settup. Thank's for that ideé.  Here is the projectfile and the PCB transfer if some one wants to build it. It's sized for fitting in a 1950A enclosure but can of cause be put in whatewer box.
It works verry well and the only change I'v made is to put a 1M pull down resistor before the first cap at IN

http://solderman.fatabur.se/swell/hat's%20Swell%20Project%20File.pdf

http://solderman.fatabur.se/swell/hat's Swell Project PCB.pdf

[edd29]

Hi All
Here's the "That's Swell" DOD FX 15 Clone.

I Just love the conductive pick settup. Thank's for that ideé.  Here is the projectfile and the PCB transfer if some one wants to build it. It's sized for fitting in a 1950A enclosure but can of cause be put in whatewer box.
It works verry well and the only change I'v made is to put a 1M pull down resistor before the first cap at IN

http://solderman.fatabur.se/swell/hat's%20Swell%20Project%20File.pdf

http://solderman.fatabur.se/swell/hat's Swell Project PCB.pdf

you so quick making this layout.THANKS!