New Insanity Box vero layout.

[digi2t]

Hi all,

The more I looked at my first vero layout post of the Insanity Box, the less I was satisfied with it. So I started from scratch, this time respecting the signal flow direction, and tightening up the board as well. It should fit quite comfortablely into a BB box. I've also incorporated Sym/Assym switching, with a trimmer to balance any volume changes that may be encountered when switching between the 2 modes (Thanks to Mark Hammer's thread some time ago on that one). I've deleted the picture of the first layout on my previous post. It really sucked. Here's the new one;



Name Value Quantity Notes
BOARD (INSANITY BOX) 22R X 19H (36 CUTS / 18 JUMPERS) 1  
C1 0.47 uF 1  
C10 220 pF 1  
C11 10 uF 1  
C12 100 uF 1  
C13 220 pF 1  
C14 24 pF 1  
C15 0.1 uF 1  
C16 0.1 uF 1  
C17 0.01 uF 1  
C18 0.02 uF 1  
C19 0.1 uF 1  
C2 0.01 uF 1  
C3 220 pF 1  
C4 22 uF 1  
C5 22 uF 1  
C6 0.1 uF 1  
D1 1N914 1  
D2 1N914 1  
D3 1N914 1  
IC1 TL071 1  
IC2 CD4049UBE 1  
Q1 J201 1  
Q2 J201 1  
R1 4.7 K 1  
R10 1 K 1  
R11 39 K 1  
R12 1 M 1  
R13 1 M 1  
R14 100 K 1  
R15 6.8 K 1  
R2 470 K 1  
R3 10 K 1  
R4 100 R 1  
R5 10 K 1  
R6 1.1 K 1  
R7 1 M 1  
R8 200 R 1  
R9 1 M 1  
SW1 DPDT 1  
TYPICAL 100 K Lin 1  
VR1 100 K Lin 1  
VR2 100 K Lin 1  
VR3 100 K Lin 1  
VR4 50 K Lin 1  
VR5 100 K Lin 1  
VR6 50 K Lin 1

Yeah, it's tight. More twists and turns than the old Nurburgring. If you're suffering from Parkinsons, you'll have fun building this board .This layout is not verified as of yet, and since my house is all in boxes (moving... crap!), I won't be able to verify it for a while. Hopefully, some brave soul might beat me to it.

So what are you waiting for? Get out your microscopes, and start soldering!    

Cheers,
Dino