would anyone also know where I could get info on alternate offboard wiring solutions for the ts-808? i'm looking to run the 808 in another project without a bypass switch - always on, but i'm not to sure how to run my wires like that.
thanks
I am also interested in how to wire pedals without bypass switching for temporary testing purposes -- are there any general diagrams or instructions for this anywhere? I'm sure it's quite simple...
http://geofex.com/Article_Folders/wrapper/wrapper.htm (http://geofex.com/Article_Folders/wrapper/wrapper.htm)
Thanks -- that's exactly what I've been looking for and spent a couple days searching before asking. Ask and ye shall receive 10 minutes later.
Hmmm... If the PCB only has only one ground connection (as opposed to the input ground and output ground as shown on the diagram), is it ok to solder both the ground wires from the jacks into the single ground hole on the PCB?
yes that should be fine... or anywhere along the ground strip
Gotcha, thanks.
;D