Hi everyone.
I'm using the Tonepad board for the Ross Compressor clone. I snagged a metal can CA3080 but I'll be dammed if I know how to bend the leads. I found a bit of information but I think I'm more confused now than before. Any insight?
Here's a picture of the board, the can and a link to the schematic.
Any help would be greatly appreciated.
Oh, and for what it's worth, Tonepad boards are A+! I built a phaser and a Rat clone with nary an issue.
Cheers,
Jason
(http://i203.photobucket.com/albums/aa227/axe_34/IMG_1622.jpg)
(http://i203.photobucket.com/albums/aa227/axe_34/IMG_1626.jpg)
http://www.tonepad.com/getFile.asp?id=9
check this datasheet (http://www.datasheet4u.com/download.php?id=629381), on 1st page there are top-views of both variants :)
Fantastic! Thanks very much.
And we have compression!! :)