DOD 250 yjm spec

[PRR]

...voltages on most dual op-amps in MOST circuits want to be:
pin1 - 1/2 V+
pin2 - 1/2 V+
pin3 - 1/2 V+
Pin4 - 0V - (continuity to GND) A lot of folks figure if they are reading 0 volts, they are good without checking true continuity to GND.
pin5 - 1/2 V+
pin6 - 1/2 V+
pin7 - 1/2 V+
pin8 V+ - (supply voltage)

This should be pinned to a Debugging thread.

[Kipper4]

It should be pinned on page 1
easy to remember info that really helps thats what us newbies need
thanks again