LM3889 amp Vero

[whomeno]

ok Guys
Tried doing another vero. Looking for advice if it is done right. Schematic is a single supply.
Not the best layout. for right now trying to get it right from schematic.
updated found some mistakes
Thanks

[FUZZZZzzzz]

try to put the vero and schematic side by side in one picture. This will make it easier to look at. Also the resolution/size of the vero is a bit low/small. Try to make it easier to read and people will look it over more easily

[snk]

Hi, Just by looking at the veroboard, it seems that there is some room left for space optimization (but i'm not an expert) :
- You might remove line O.
- Then, remove the cuts at A6 and C10.
- Move the 100µF cap to row 15, and turn the negative side to line E.
- Then, put your VOL02 wire to E20.
- Also, it seems that you can move everything after column 13 one row to the left.
If I'm right, it should help you make your layout 3 lines and 1 row smaller.