CryBaby Header--Pinout?

[isher1992]

So, I bought a JD Crybaby PCB, modding it and such.  Sadly, it's going in an empty shell with a new pot and the shell was a 95F, so I can't look at it to figure this out, because the PCB is totally different.

Sorry these are crappy cell phone pics, my current camera uses CF cards and I don't have a CF reader on hand anymore.

Here's the PCB, it's a 2007 board, REV I.





If someone could show me where everything goes, that would be great.  I've tried finding pictures of a similar PCB, but haven't found any gut shots on the Internet that look similar to this one (at least not visible enough to figure out).  I would like to retain the DPDT switching if possible.

[isher1992]

Okay, I think I found an image now!  But still can't quite tell on the pot.

[Jdansti]

Hang tight and maybe Joe Gagan will give you some help. He's the resident wah expert.

[Paul Marossy]

I am looking at GCB-95 Rev G, with header at top, looking at the component side, from left to right:

Black wire = battery ground
Red = battery positive
Black = "CCW" on pot
Green = input jack, tip
Yellow = "SL" on pot
Blue = "CW" on pot
Purple = output jack, tip
The last pin on the right is also connected to 9V.

Does that answer your question?

[joegagan]

. edit. i don't know the pinout

[Paul Marossy]

I don't know why they would change the header. Then they would have have a different wiring harness for that one model. Wouldn't make any sense to the MBAs...

[joegagan]

.