Eagle + Vref

[karbomusic]

I have a design where I've done the schematic in Eagle and built a couple Vero board versions so both the schematic and Vero layouts are verified. Due to the number of Vrefs I diagramed the power section separately (still within the same schematic) and used labels to refer to +9V and +4.5V respectively. Do I need to actually connect these in the schematic for them to appear in the PCB view? I want to have some PCBs fabricated at some point and I'm looking for general advice as well.

[deadastronaut]

as long as the 4.5v reference point labelled (usually VA or VB ) is on the power section, and is also on the rest of schemo where they should be , they should connect on the pcb...

if your not sure check you air wires..

[karbomusic]

I wonder if it is the labeling then. I'm flying completely blind and don't know what airwires are LOL. Sounds like a good reason to hit F1 and see what happens.  

[deadastronaut]

checkout:

http://www.diystompboxes.com/smfforum/index.php?topic=99864.0

vid 3..


air wires= rats nest wires...connections.

[karbomusic]

checkout:

http://www.diystompboxes.com/smfforum/index.php?topic=99864.0

vid 3..


air wires= rats nest wires...connections.

Fantastic, I'll just watch them all. Thank you!