3pdt true bypass PCB

[rockaffe]

With the premise that this is my first experience with Eagle Cad and with the creation of a PCB, I would like to ask you, before sending the file for printing, if this board seems correct to you. I also attach the diagram from which it is derived.
Thank you!

[r080]

The schematic looks right, so Eagle shouldn't let you get too far off with the PCB.

I am not super experienced either, but it looks like you could make better use of the ground plane by switching the sides of some traces, and then there are a couple traces you could probably move to give them more space between pins.

Are you planning for the LED to be that close to the switch? Also, did you make sure your rules are set up so you are well within the capabilities of the manufacturer you have chosen?

[rockaffe]

The manufacturer just approved the design so I guess the rules are ok.
Thanks for your advices, they will be very helpful on my next design