LTspice noob question

[suryabeep]

Hi everyone,
dunno if this is the right place to post this, but I have a noob question about LTspice. I just downloaded it today and started with a common emitter amplifier to warm up. I'm using LPB values, but it doesn't work. What did I do wrong?

[antonis]

LTspice (and its symbols) isn't familiar to me but is actually R4 0.001 Ohm..

[GibsonGM]

LTspice (and its symbols) isn't familiar to me but is actually R4 0.001 Ohm..

With LT you must say "1MEG" for 1 megohm...I think, as Antonis says, "1m" makes it divided by 1,000!

After you run the simulation, if you do not see your output signal, double-click the output node ("OUT").