Madbean total recall help

[Atodovax]

Hello everyone i just finished building a total recall from madbean using de xvibe chips and the pedal sounds pretty well but the repeats and to distorted. I tried biading as recommended but had no luck. Im getting a distorted signal into the input of ic6. Im wondering if this is normal or should i have clean signal into that input?

[vigilante397]

Sorry I don't have an answer, but I have the same issue with a build I did so I'm following this post in case someone has a good answer

[Atodovax]

Do you have distorted signal in pin 7 of ic6?

[vigilante397]

Do you have distorted signal in pin 7 of ic6?

I'll have to double check, I thought it was clean going into IC6 but dirty going into IC7. Could have been dirty on both though, I put this build on the back burner a couple months ago

[Atodovax]

If yiu manage to check that tell me... I have distortion on the input and that seems strange

[vigilante397]

So I finally got back to my build and I'm not sure what was happening before, but it actually works fine now I definitely do not have distortion on the input. I have the typical BBD noise on my delayed signal, but other than that the signal is pretty clean. So a few questions:

Is this a board you purchased or one you etched?

What are your voltages?

What are your trimmer settings at?

Can I see some pictures of your build?

I don't have the same issue as you, but hopefully I can still help