Holdown resistor locations...

[Legis31]

Can holdown resistors be mounted directly across the lugs of the input/output jacks or do they need to be mounted on the F/X board itself?

How about at the in/out lugs on the stomp switch to ground?

Thanks!

[petemoore]

You may notice some highs get rolled off if you start putting them on the jacks... a capacitro from signal path to ground on the 'outside of the BP switch.

[Legis31]

The effect in question is a BMP from Tonepad....a few highs knocked off may not be a bad thing! I knew caps would roll off some frequencies...I am just looking for the easiest way to control the popping during switching.

Thanks for the incredibly FAST response !!!

[mattv]

They need to be on the effects-side of the switch, not the jack-side, or else they can't do their job.

[Legis31]

Thanks much, guys....I appreciate it!