Help with the Line 6 Floor Board!!!!

[Sethmetal]

I have a Line 6 Floor Board Controller. It has mechanical actuators(They look like the heavy duty stomp buttons on a MXR Flanger). These actuators are just the mechanical means of pressing on the pad switch attached to the circuit board.

I figured out that my switching errors are due to the pad switches being old. They simply need to be replaced. Line 6 won't help me figure out a suitable replacement switch. Does anyone here know of a good replacement and where to find it? Thanks so much I gig out often and will surely die without channel switching capabilities.

[Wailin]

I bought some from digikey...EG1023-ND..I think that is what you need.  You might want to measure yours and check out the specs on there site.  
BTW...these are also used in DOD pedals and the Rolls Midi Buddy.  Basically
the switch from a TS-9 without the "nib" on top

[Sethmetal]

I was directed to www.smallbearelec.com, they have the actuator, but I'm not sure the switch is what I want. I'll check digikey...thanks