EZ Vibe mid build question and partial success !!

[petemoore]

Board components all placed [i think] and LFO testing is working excellent except the speed control, which does pretty well too but*
 I've got slow slow enough [I reduced the 1k stop resistor just outside the 100k speed pot], but fast and too fast settings are using alot of the range of pot travel.
 I'd rather not make a mess of the otherwise great looking board, so I'll say "I think"
 I think reducing the 100k speed pot value will reduce top speed and spread the slower speeds through more of the pot...
 OT Optimally [dohh maybe] I'd like to reduce the travel of the pot from fully CCW [slow] to half way or a little less for fast and use a simple foot treadle case to control it.
 I'd at least like less fast and finer control over the slow to medium speeds.
 I'll see if I can get a link to the schematic...
 Here it is
  http://www.hollis.co.uk/john/easyvibe.jpg

[RDV]

You just need that basic reverse audio pot, but it'll still be bunched up somewhat. I don't think it's completely avoidable.

RDV

[RDV]

 

[vanhansen]

WEEEEE......This is fun