wah inductor instalation question

[gringo699c]

 I have the dulop wah cbg95, with the rev-d board.
I just bought the red fasel. the old inductor has four legs and the red has two.
Looking at the bottom of the board with the words dunlop on the top and revd on the bottom
left, which side do I put the new inductor on. Does it matter?  Obviously it wont fit in these slots so I put wires in and run them to the legs of the inductor, correct?
So I assume I just jumper the holes on the other side where the other legs once were?
I am a total novice so sorry if this has been answered many times, thanks.
Chris

[no one ever]

if you look closely, you see the two horizontally aligned holes are already jumpered with pads/traces. just install it in diagonally opposite holes   (having the wah oriented so that jacks are on left and right of inductor).

[gringo699c]

   I see what yer saying. Two of the holes were two of the legs were are real close
to two other holes and were jumpred with solder.
  so its the other two holes I put the new inductor in, thanks for your help and i will report back.
Chris