Help Identify cap for Flanger mod

[stompbox steve]

Hello
I have seen all the prior posts on Boss's Flanger BF2 mods.  Right now, I am just looking to do the C7 mod, less metallic.  Problem is I don't know which is C7.  the caps are not marked but the ICs, diodes and transistors are.

Can someone look at these pictures and identify which is C7?
http://photobucket.com/albums/y229/stompboxsteve2112/?sc=2

actually while someone is looking, how about pointing out R29 too.
thank you much, Steve

[Mark Hammer]

C7 is is the "greenie" cap located at the bottom right of that first picture.

In that second picture, if you look to the left, you will see a 100uf cap lying on its side.  Just north of that will be a transistor, then a greenie cap, then 3 resistors in a column, then the chip.  The 27k resistor just beside the greenie cap would be your R29.  That is the one that if you increase its value, the flanging effect will be reduced in intensity.  If that was your plan, I would suggest making it 22k and placing it in series with a 100k or 250k pot, allowing it to be just a little stronger than the clean signal, or a lot lower than the clean signal.

[stompbox steve]

Thanks
Let the fun begin, Steve