Dr. Boogey (messy as hell) vero layout

[Xavier]

Please check if everything is right. I really want to build this one but it's not an easy one to draw....

[MartyMart]

VR 2 looks wierd, goes through a 5n cap/1m resistor to gain 1 and Q3's source connection ??
Q2 also seems connected here, via the same path .... ?
The large "links" are on the back of the board ..?

Needs a "re-think" I'm afraid, but you're getting there 

MM.

[Xavier]

Let's see......VR2 looks right to me? from +9 to the trim there's C7 connected to ground, which is fine according to the schematic?

Gain 1 is connected to ground, according to the schematic, hence the reason why is connected to ground. Same for Q2

The links are intended to be done using "covered" wire either side of the board.

[MartyMart]

VR 2 doesn't have a connection to Q2's "drain", remove the "cut" next to C9/VR2's lug 3.

After that, looks good ... but boy that's hard to follow 

Cheers,

MM.

[Xavier]

Thanks Marty

Otherwise everything else looks right?

I know it looks messy, however I didn't want to use an xtra-long vero piece.....maybe I'll try with a perf layout anyway.....