AMZ FX ANALOG ALCHEMY GEOFX MEF ROG MEF DIY WIKI

RV-3 signal leaking through

Started by JasonG, September 02, 2006, 06:33:18 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

JasonG

September 02, 2006, 06:33:18 PM
Hey gang
I have an Rv-3 that I used an ACA power adapter with before I knew better. And now when it is set on delay it leaks a small amount of delay in the dry signal. On a digital pedal like that would it be as simpal as a zener diode or are we talking a fried chip? Thanks for the help !
Class A booster , Dod 250 , Jfet booster, Optical Tremolo, Little Gem 2,  mosfet boost, Super fuzz , ESP stand alone spring reverb red Llama omni-drive , splitter blender ,

NEVER use gorilla glue for guitar repairs! It's Titebond , Elmers, or Superglue

JasonG

#1
September 02, 2006, 07:55:54 PM
Does that sound right to you guys ? or am way off ?
Class A booster , Dod 250 , Jfet booster, Optical Tremolo, Little Gem 2,  mosfet boost, Super fuzz , ESP stand alone spring reverb red Llama omni-drive , splitter blender ,

NEVER use gorilla glue for guitar repairs! It's Titebond , Elmers, or Superglue

cjlectronics

#2
September 03, 2006, 12:05:40 AM
Replace both of the 2SK30A's that switch the clean and wet signal.  I've seen these leak.  They are cheap and I think Steve over at Small Bear carries them.

CJLectronics
Print
Go Up Pages1
User actions