ts-808 offboard wiring W/O a bypass switch at all.. how do I do it?

[samuel1]

I'm looking to wire a ts808 i built without a bypass switch, simply a power swtich. I plan to build it into another project I have.

I'm not to sharp about offboard audio wiring... I'm also pretty new at everything else.

Can anyone tell me how to wire the power and input cables up without a bypass in words I can understand?

[samuel1]

i'm new to the forum and i guess i put this in the wrong place. i'll just post it in the general? thanks.

[Barcode80]

just take the ins/outs from the circuit straight to the jacks, then put a switch on the ground lead of the battery/jack.

[samuel1]

I'm pretty un-knowing about these things some one will have to spell it out for me... There are three connections, +9V, GND, and IN. I have two wires coming from my input jack, and +/- wires power wires. I see four wires and three connections i'm lost!

I'm pretty good at accurately following directions which has gotten me well through the entire unit but the moment I have to make up something on my own I get lost very quickly.

[Bobv]

The sleeve of the input jack is ground - so it will go with the ground of your circuit and ground of the battery (black wire)

[samuel1]

so the ring of the input goes right to the black power wire, the positive goes to the +9V, and the tip goes to the IN?

[Barcode80]

yes, and also a wire from the middle lug of the volume pot will go to the tip of your output jack.

[samuel1]

middle lug of the volume pot will go to the tip of the output jack... I think I get everything thanks alot