Bee Baa Clone Wiring Diagram Help

[pedalmaker]

Hi.

Ok, Im new to this.
I got a schematic from GGG, and Im trying to wire it up with TB, & LED.
I am going by the schematic to try and suss out the wiring for myself, and I have a diagram (below)
Can you guys please take a look and see if I did anything wrong?
I appreciate it!
Thanks guys

[pedalmaker]

Oh, here is a pdf form GGG with schematic and wiring for Bypass/MBS

http://www.generalguitargadgets.com/diagrams/geo_baa-baa.pdf?phpMyAdmin=4a28f86a515b7883e7bc35a68d4e7b6d

[pedalmaker]

BUMP

Anyone?

[Dan N]

As far as the stomp switch, it looks OK. You do need a current limiting resistor for the LED. 1K 1K8 2K2 are normal values.

Use a .022 cap on the tone pot (.0022 does not give much effect) and don't use C10 for a more authentic BeeBaa.

[pedalmaker]

Thanks Dan. Yea, I got the Current Limiting resistor and other caps spoken for, I just didnt specify their values, instead I just drea a colored box to rep that a res or a cap that the schem suggests will be there.
I think the switch is good, too.
Im more worried about IN and OUt from PCB and if the power is hooked up correctly.
Anyone ?