MY BOOST Schematic and switch pop query (oh no another)

[letsgocoyote]

so here is a boost i have made:


it sounds good (to me at least).  clear and neutral, it buffers between zero and 12 o clock with little or no volume added, boosts cleanly between 12 and 3 o clock, and starts getting loud, gritty and overdrive past 3 o clock.  i like it.

my only problem is, ive been having switch popping that im not used to.  maybe jsut louder than im used to.  i always use 1m pulldown resistor at front but that didnt take care of it so I have also added one to the end but there is still a switch pop when engaging the effect.  so im pretty sure its the LED.  im using the superbright 3mm variety from smallbear.  yellow color.  i normally use a 4.7k resistor to get it nice and bright.  more resistance on an LED reduces the switch popping correct?  i could probably use a 10k resistor and still get acceptable led brightness, if that is the case.  jsut thought i would check to see if there were other issues causing popping.
mainly, ive never built a circuit with no volume control on the end so i dont knwo how that affects things

[foxfire]

i'd start by disconnecting the led to see if it is in fact the led causing the pop. if it is the led then try this, http://www.muzique.com/lab/led.htm.

[letsgocoyote]

tried those too.  still pops

[ayayay!]

What about this one?  Haven't tried it. 

http://www.dazatronyx.com/support/true-bypass-technique.pdf
Or what about the Millenium 2 bypass?