Looking for a part but not sure what it is called...LED lead sleeve maybe?

[skiraly017]

Voodoo Lab uses this peice of rubber that slips over the exposed portions of the LED leads in their pedals. Unfortunately I do not have a picture but does anyone...

a) know what I'm talking about?
b) know what they're called?
c) where and can find them?

Thanks guys.

[theehman]

Shrink tubing?
Radio Shack or any electronics parts supplier.

[skiraly017]

Shrink tubing?
Radio Shack or any electronics parts supplier.

It's not shrink tubing (I know you can do the same thing with shrink tubing). It's a spongy material maybe a little more than 1/8" in diameter and has two holes for the leads. Almost looks like the black rubber pipe insulation you get at Home Depot.

[GREEN FUZ]

Like this?

http://www.banzaieffects.com/LED-neopren-holder-3mm-pr-17382.html

[skiraly017]

Sorta kinda but without the lip/flange. It's a straight tube. Voodoo Lab uses it to cover the inch or so gap between the PCB and the bottom of the LED where the leads are exposed.

[ollie]

What I've done before is stripped some wire and used the insulation from that - would that work for you?

[GREEN FUZ]

Alright, have a look at this then. I`ve a feeling something HERE will fit the bill. If not, I give up.

[Gus]

  plastic coffee stirrer might work

[skiraly017]

Alright, have a look at this then. I`ve a feeling something HERE will fit the bill. If not, I give up.

That's close enough for me to contact them, thanks!

[bipedal]

Sort of like the plugs that come with LED bezels, like the third (l to r) piece http://www.smallbearelec.com/Detail.bok?no=94?  When I've ordered bezels, sometimes those plugs are plastic, sometimes rubber...