Please check me. Sansamp gt2 switch wiring

[Ibanezfoo]

   I wired up a GT2 using the 2007 Tonepad board and layout.  I've searched all over about how to wire up a rotary switch.  I found a few posts that seemed like they were supposed to have images but there were none shown... I'm guessing the links have expired or the images were removed.  Here is how I wired up mine, can somebody tell me if this is correct?  I'm only asking because its not really working.  The switches seem to do what they are supposed to but the volume is extremely low.  Before I start tearing into the components and soldering I want to make sure all the basics are covered and this is the one thing I wasn't sure about.  Heres how I wired it on a rotary switch:



As the switch is rotated:

Position 1:  S1A0 links to S1A1 and S1B0 links to S1B1

Position 2:  S1A0 links to S1A2 and S1B0 links to S1B2

Position 3:  S1A0 links to S1A3 and S1B0 links to S1B3

The 0 pads (S1A0 and S1B0) don't link together, right?

Thanks for any help!

[txomin]

in this link http://www.pisotones.com/GT2/GT2.htm you have all the info and the pics.I build mi GT2 with this documentation and works fine.

Good luck

[Ibanezfoo]

Thanks for the link, though I don't speak Spanish at all.  I rebuilt the whole thing and it works fine now.  I must have had a cold joint or something.  For the record, my switch wiring was correct and works fine in case anyone else is looking to wire one up.