Help with 3 Cascaded LPB-1s

[Gruesomania]

Hi, not sure if this is the right section but I've recently gotten into pedal building and wanted to build a clone of the Dwarfcraft Internet overdrive. I couldn't find any layouts for this but did find a thread where Aen (the creator) said that it was just 3 cascaded LPB-1s with a foot switch to add or remove the second one. Anyway so i used this schematic:

This is my first attempt at making a vero, i had to try and play around with the layouts to get them to fit in the smallest space and so the Trim pot (for adjusting the gain of the boost in the second stage) would fit on the board. So it's a little messy but here it is:

There's a trace cut under 5f as well that's not too visible.
I was just wondering could someone give it a look over and see if it all looks right before I go out and build it. Thanks in advance

[slacker]

Looks good to me. Welcome aboard

[Gruesomania]

Thanks. I'll collect the parts and get building after I finish exams next Thursday. Hopefully all goes smoothly.