Could someone be of help in checking my wiring?

[Bandwagonesque]

I've been having trouble getting my charge-pumpless klon(e) to make any signal and I may think its because of my inexperience with wiring up a stomp box correctly over anything actually wrong with the circuit itself. Below is the wiring scheme I used to put together my last attempt, and while i'm sure its about 3/4th's correct (thanks to another friendly cat elsewhere), I still have doubts if I'm putting my grounds in the right place or if im getting confused with what goes where in regards to the dual gang'd gain potentiometer. am i missing anything? Could someone be so kind as to check over my diagram to make sure everything is where it should be before I go ahead and start probing and pulling things apart on the circuit to figure out whats going wrong? Thanks for any help.

[Le québécois]

Unless you use aluminium enclosure as a grounding case, you should also connect the ground of the input jack to the output jack.

good luck

[Bandwagonesque]

hey thanks alot, the help is much appreciated. ill give it a go and add that extra ground connection to see if that gets this thing workin