simple 2 knob hi gain distortion..collaboration?

[jogina111]

thanks for the trick Rob! What can I say? i think this one sounds better than the krank DM IMO. Meets my shred tone standards.

[deadastronaut]

^ cool, yeah i built a few versions of the krank, and it fizzed like a sod...so i gave up on that...

its a great little mean ass pedal..my mate has my old one and loves it.

did you try a tone on it?..

try this one..

http://www.aronnelson.com/gallery/main.php/v/chickpea/bluesmetalthrashtone.jpg.html

[jogina111]

where do I have to stick a master volume in that tone control? And what value.?

[caspercody]

I would try a 100K off of pin 2 of the tone control.

[deadastronaut]

^ yep..

[jogina111]

I mean, should pin 2 or 3 of the master pot(dial pointing to face) be connected to that corner between C2 and 50-100k tone pot? if not, on which point should I  stick the master pot?

[caspercody]

Yes. Pin 3 connected to that corner between C2 and and pin 2 of the tone pot. Then pin 2 of the volume would be your output, and pin 1 would go to ground.

[deadastronaut]

 

[Perrow]

Went looking for something a little more than an LPB-1 for the 'SMT Thread' and this bastard popped up on the 'show new replies page'. So here goes, totally unverified, SMD 386 drops in the empty space, through hole components on the reverse side (back of screen). Test for the value of 'VR1' and order a resistor of the appropriate value.



300dpi.

[jogina111]

is it possible to add a TMB tonestack on this bastard? Do I need to add a booster or buffer afterwards?

[deadastronaut]

@mark: try it on breadboard, but i'm pretty sure the amp will have lots of output to handle it..