U-Boat Schmoo Boat

[bifbangpow]

Got a U-Boat here that isn't getting any sound when the fx are on.
ICIs all read 1-5 except for the corner peg which reads 8.8 on all of them.  So that looks good.  I get clean sound when the FX is bypassed. LEDs light up perfectly. And I'm using a printed circuit board so no etching problems....  I feel like I'm trapped in a cold joint hell.  Help me!!!

The project:  http://diy.thcustom.com/shop/u-boat-v1-1-pcb/

[PRR]

> ICIs all read 1-5 except for the corner peg which reads 8.8

We expect +4.5V on most, and a Zero on the other corner.

[vigilante397]

I agree with Paul, double check the voltages on your op-amps. Also, try taking the voltages with the ICs removed as well to make sure it isn't just a bad IC. Voltage at an empty socket can help trace down cold solder joints if they're there.

I think I have one of these boards floating around sonewhere, I might try to find it if your problem persists.