Line6 DL4 no taptempo

[michielstekel]

Hey guys!

I'm kinda new to the diy-pedalworld (I'm learning a lot from this forum!) and I'm modding a Line6 DL4 now.
I just replaced the switches. The taptempo-switch was not working, (led was still blinking, but tapping did not alter the tempo of the delay) so I was hoping that it would work after replacing the switches, but it doesn't.
I found out that one of the resistors, R32 is missing. Could that be the problem? And which resistor should I place there? Or could it be something else that causes the problem?
Thanks for your help!

[slashandburn]

I think this is a different beast to what most folks here are used to troubleshooting, I'm afraid. Good luck with it.

Take it youve tried powering it up with the A and Tap  buttons held down? I have a dodgy line 6 amp that gets confused and needs a factory reset every now and again.

[PRR]

> R32 is missing. Could that be the problem?

Yes.

[michielstekel]

Thanks guys,
any idea what resistor I could place instead of the R32?

[steve_h]

Schematic says R32 is a 8.06k 1% resistor