Debugging my first two DIY boxes (EHX LBP-1/Fulltone OCD)!

[Gfighter]

Just to make sure this post is complete I made a mistake in ordering my parts I mistakenly choose a 150pF Cap instead of a 150nF Cap wich set the cut frequency about 1000 times higher than expected. What a dumb mistake.

So I only have to figure out a way of fixing my OCD. Compared it with a Fulltone OCD and it sounded surprisingly close just a bit more muddy which could be due to the fact i compared against a v7 one. But I get really high gain really early on my gain pot. Can´t I chage a resistor value to make it more "useable"?

[thermionix]

But I get really high gain really early on my gain pot. Can´t I chage a resistor value to make it more "useable"?

If you are using a linear taper pot switch to log (audio) taper.