9 knob fuzz

[EATyourGuitar]

I made a new schematic for the pcb. it is exactly the same to the old one if you include the off-board wiring. I usually write the documentation after I sell the pcb. some PCB's take a while to sell. like who would want to torture themselves wiring up a 9 knob fuzz with daisy chaining all your nets off board. I would be surprised if I sell a pcb. people should understand that I do not make money writing documentation to sell one PCB but I do it to help people out. I support the community.

[mth5044]

It was one of these, I can't remember which.
http://www.hammondmfg.com/dwg16.htm
http://www.hammondmfg.com/dwg16_CWW.htm
http://www.hammondmfg.com/dwg17.htm
http://www.hammondmfg.com/dwg16Steel.htm


Here is a last of all of Hammonds' smaller enclosures
http://www.hammondmfg.com/scpg.htm

Some of those traces are very close to pads on that PCB!

[antonis]

I made a new schematic for the pcb. it is exactly the same to the old one if you include the off-board wiring. I usually write the documentation after I sell the pcb. some PCB's take a while to sell. like who would want to torture themselves wiring up a 9 knob fuzz with daisy chaining all your nets off board. I would be surprised if I sell a pcb. people should understand that I do not make money writing documentation to sell one PCB but I do it to help people out. I support the community.

My bad...

(i was just observing the item orientation on PCB..)

[EATyourGuitar]

no problem. everyone is welcome here.

[Nico3p]

corrected some errors in the schematic
https://farm3.staticflickr.com/2945/15182634869_bd6bb1258f_o.gif

SW1_A: 1-3 are in short circuit?!?

[ElectricDruid]

I *can't believe* you haven't put an "LED brightness" knob on it

Tom