Ruby Amp layout check

[suryabeep]

Hi everyone, I did a layout for the ROG ruby amp all by myself (super proud cuz it's my first lol). Can anyone check if this is correct before I solder the components onto vero? I saw an earlier post here with a layout for the Ruby, but I wasn't sure if it was correct since it had the input going to the Source of the MPF102 instead of the Gate.

[bluebunny]

In the orientation you've shown, your JFET goes D-S-G (top to bottom), so your input is currently connected to the source - it should be to the gate.  So move your input label down a row, then swap the 1M5 and 3K9 resistors.  Then move the bottom lead of the first 47nF cap up a row.  The rest of it looks OK to me.

[suryabeep]

In the orientation you've shown, your JFET goes D-S-G (top to bottom), so your input is currently connected to the source - it should be to the gate.  So move your input label down a row, then swap the 1M5 and 3K9 resistors.  Then move the bottom lead of the first 47nF cap up a row.  The rest of it looks OK to me.

Thank you!