Tube screamer clipping daughter board issue

[Fish_bone]

Hello all! This is my first post here. I need help determining where to wire in my clipping daughter board. I copied YouTube's diy pedals and made a thumb wheel diode clipping board. I had someone on Reddit give me a run down, but I am afraid it's wrong. Their board graphic is laid out different from what I can tell. Let me know what I can do to help you help me.

[brianq]

1st of all, Welcome you got your 1st post out of the way. TIP: Usually  when you have a question, posting your schematic or schematics accompanied with your pics is a good way to open up your discussion. Posting a schematic will give us a better understanding of what your getting at. Again, welcome 

[J0K3RX]

I believe it's an Aion Stratus/TS9... Schematic is in the project doc, if you need it.
https://aionelectronics.com/project/stratus-ibanez-ts9-od808-tube-screamer/

Not sure about the thumbwheel clip mod.. Prolly just some some different clipping diode configurations that you can roll through with a thumbwheel pot.. Just a guess.

Just wire it into the board in place of one of the clipping options...

[Fish_bone]

1st of all, Welcome you got your 1st post out of the way. TIP: Usually  when you have a question, posting your schematic or schematics accompanied with your pics is a good way to open up your discussion. Posting a schematic will give us a better understanding of what your getting at. Again, welcome 

Thanks for welcoming me, and for the good tip.

I believe it's an Aion Stratus/TS9... Schematic is in the project doc, if you need it.
https://aionelectronics.com/project/stratus-ibanez-ts9-od808-tube-screamer/

Not sure about the thumbwheel clip mod.. Prolly just some some different clipping diode configurations that you can roll through with a thumbwheel pot.. Just a guess.

Just wire it into the board in place of one of the clipping options...

you are correct, it is an Aion Stratus board. You are also correct about the clipping board. So what you are saying is that I am over complicating things? I figured with there being a spot for a switch and so many options (D2-D9) and not all the traces are connected...I am worried about finding the beginning and the end of the clipping section as a means of by-passing the provided onboard option. I can not find a Schematic that is not in PDF form...I hope a picture of a bare board will work. I think soldering IN on a leg of R6 and OUT on R7 makes sense, but I am new to this and lack the ability to know if I am right or if there is a dedicated pad I can use. Your help is greatly appreciated.

[Fish_bone]

I still feel lost on this.