Rebote 2 low pass filter questions

[Gringo]

Finished a rebote2 delay from tonepad yesterday, and i'd like to make the repeats  a tad brighter and louder. Here's the project:

http://www.tonepad.com/project.asp?id=27

Joep's build report suggested lifting the .01 cap to ground after the 1k resistor and before the repeats' pot section (around pin 14), but that was not enough. Any tips on where to continue tweaking?

[freebird1127]

briefly taking a look at the circuit..

try reducing the value of the 1k resistor before the lifted 0.01uF cap, or try reducing the value of the 0.027uF cap shown beside that same 0.01 uF cap... maybe?

hope this helps