EA Tremolo GGG layout no sound Q1 voltage wrong help

[dboy]

I just finished my GGG Improved EA Tremolo and it doesn't work.  I used 50k audio pots instead of the 25k since Small bear did not have them.  It was suggested that these would work fine by another member on this forum.  I am sure these are fine.  My problem seems to lie around Q1.  I used a 2n3904 as suggested.  My voltages do not match the tested voltages from GGG.  My voltages are E=0 B=.003 C=8.8.  It should measure E=0.8 B=1.5 C=6.0

All other voltages measure good.  I have replaced R2,R4,R5,R6.  Still no sound.  Bypassing with stomp switch works.  Help... 

Thanks,
dboy

[dboy]

Well...  R3 is supposed to be a 150k resistor.  I had a 150 ohm resistor.  Changing that fixed it.  It is working just fine and sounding sweet.
dboy

[Transmogrifox]

I'd second the above.  The problem likely falls within that bias network.  Make sure you double check the connections around R2 and R3 and Q1.