Dumb newbiee question

mac dillard · July 14, 2006, 02:00:01 PM

On a vero board layout drawing what is the red square with the + sign in it?

Paul Marossy · July 14, 2006, 02:03:00 PM

That's where the positive terminal of the battery gets connected to the board.

mac dillard · July 14, 2006, 02:19:01 PM

Thanks paul, but I don't think that that is what I am refering to. Look are MartyMart's post of Austin Vero Layout Here. Below..The red squares on it are what I am asking about.

mac dillard · July 14, 2006, 02:22:45 PM

On second thought maybe I'm just not reading it right.

jonathan perez · July 14, 2006, 02:30:31 PM

thats not a dumb question.

this is a dumb question:
if the united states had 40 people standing in jello, where would the sausage live?

any · July 14, 2006, 02:41:34 PM

it's where you cut the vero tracks.
(you need to carve throughthe track so no electricity can be conducted between them.)
Use a sharpie to cut two lines close to eachother (about 1mm) firmly press so it goes through the copper.
Now use the point of the sharpie to pry the little slit of copper inbetween the lines you created by cutting from the board.
Does that make sense?

any · July 14, 2006, 02:42:13 PM

Quote from: thebattleofmidway on July 14, 2006, 02:30:31 PM
if the united states had 40 people standing in jello, where would the sausage live?

in the white house...

The Tone God · July 14, 2006, 02:54:11 PM

I think the red square with a plus means you king them. But if you turn the board the "+" becomes a "X" so now you have to try to block by picking Whoopi Goldberg.

BTW, there are no dumb questions only dumb people who don't ask questions.

Andrew

billings · July 14, 2006, 04:09:33 PM

Quote from: any on July 14, 2006, 02:41:34 PM
Use a sharpie to cut two lines close to eachother (about 1mm) firmly press so it goes through the copper.
Now use the point of the sharpie to pry the little slit of copper inbetween the lines you created by cutting from the board.
Does that make sense?

It does if a sharpie is a small hobby knife.

Somicide · July 14, 2006, 04:14:09 PM

Quote from: billings on July 14, 2006, 04:09:33 PM
Quote from: any on July 14, 2006, 02:41:34 PM
Use a sharpie to cut two lines close to eachother (about 1mm) firmly press so it goes through the copper.
Now use the point of the sharpie to pry the little slit of copper inbetween the lines you created by cutting from the board.
Does that make sense?

It does if a sharpie is a small hobby knife.

X-Acto knife

mac dillard · July 14, 2006, 06:28:44 PM

Thanks ANV

News:

Dumb newbiee question