when wiring an led (mill bypass)

[jlullo]

on my last pedal, i had wired up an LED w/ mill bypass.  I haven't gotten this working yet, so i was wondering some advice for the next time around.  How do you guys actually wire up the led?  i have mine in a bezel, and both of the leads clipped short.  Then i soldered a piece of wire which connected to the resistor and the switch.  Is soldering wire directly to the leads the best way to do this?

[boogietube]

That's what I do. It works for me.
GGG has an led and Millenium board layout here:
http://www.generalguitargadgets.com/pdf/ggg_millenium1.pdf

[jlullo]

awesome!  that's handy!  thanks a lot

what is the first board used for? why is there a J201 and 1N914 on it?

[jlullo]

nevermind!  i found the explanation on the ggg site   thanks again!