Anybody willing to make a template?

[Jerry J]

I'm doing my first pedal build and it just a simple 3-switch setup with status LEDs on a 1590 box. There are also three jacks on one edge and and DC input jack on the other edge.

I am in need of a drilling template, please. I'm such a bonehead when it comes to the drawing programs. 

[CynicalMan]

No promises, but I'm making a few templates and I might be able to get one together. Which 1590 box is it?

[Jerry J]

No promises, but I'm making a few templates and I might be able to get one together. Which 1590 box is it?

That would be great if you do get the chance.

The box is the 1590 painted blem from Pedal Parts Plus. Really good people there!

Here is the link to the box. http://www.pedalpartsplus.com/mm5/merchant.mvc?Screen=PROD&Store_Code=PPP&Product_Code=0003&Category_Code=ENC00

The three switches would be in a "V" pattern with enough room at the upper side for the three 1/4" jacks. The LEDs would be above each switch to indicate the switch status.

And I'm thinking that the 2.3mm DC input jack could be on the same side as the 1/4" phone jacks. 

       
        _______________________________________
        l                                                                   l
        l             jack        jack        jack          9v            l
        l               O           O           O            o              l
        l ________________________________________l   

     
        ______________________________________
        l                                                                     l
        l    led                                                led         l
        l    o                                                    o          l
        l   O                                                    O          l
        l   switch                                        switch         l
        l                             led                                    l
        l                             o                                      l
        l                             O                                      l
        l                           switch                                 l
        l________________________________________l

As you can see I am a bit challenged here.

[CynicalMan]

Are you getting a drilling template for personal use or for PPP? They need full measurements for their CNC.

[Jerry J]

This will be for me. I have a drill press so it should be a piece of cake, right?

I just measured the box at: 3 9/16" by 4 9/16" by 1 5/16" if that helps.