Switch wiring for no 9V clip, just DC jack

[glesconz]

Hi, this may sound dumb, but I intend to build 3 devices (input - compressor - OD - Fuzz - output) in one box, with a single 9v supply (no batteries) powering them all. Assuming this would be ok, would I just omit the battery clip between the input jack ring and +ve rail on the PCB?

I would see what the current draw is for each unit and make sure the power supply can easily handle the total..

Thanks for your help
Glenn

[anchovie]

would I just omit the battery clip between the input jack ring and +ve rail on the PCB?

Yes.

[glesconz]

Thanks for the confirmation

Glenn

[jkokura]

You can use two mono jacks instead of one mono one stereo if you prefer.

Jacob

[petemoore]

  DMM here 'n there +/- go...where [ok?
  And there is no continuity between +/- ?
  One of the two, + Or - [the correct one for the polarity used] does and the other doesn't connect to ground.
  In both jack conditions [plug in / no plug].
  Then the circuit / power supply conditions are probably be ok, worth a check.