Damaged traces on Boss MT-2

[soupbone]

I pulled this pedal out today,and it was one of the first pedals i modded.I burned the traces of one cap;C-23 (.015uf-153pf).I know you can "hot-wire" the cap,I'm just not sure where to jumper the two leads to?It looks like one side can jumper to R-31(4.7k),and the other goes to ground maybe?Here's the schematic;http://www.hobby-hour.com/electronics/s/schematics/boss-mt2-metal-zone-schematic.gif

[deadastronaut]

yep that looks right....as long as  1 cap leg goes to the bottom of 4.7k, and the other goes to a ground it'll be fine by the looks of it.....

[soupbone]

yep that looks right....as long as  1 cap leg goes to the bottom of 4.7k, and the other goes to a ground it'll be fine by the looks of it.....

Where would the ground be on the board?

[deadastronaut]

any nearest ground point will do.....without a pic i can't tell.....

[soupbone]

any nearest ground point will do.....without a pic i can't tell.....

http://s1143.photobucket.com/albums/n628/soupbone71/pedal%20pics/  Here's a pic of the board.The pic is not that great ,but you should be able to see the burnt land on the board.