Eagle -Power & GND connections don't show up - Opamps, Tube Heaters...

[Pigyboy]

Using Gaussmarkov's library using the 5532 opamp from the IC's folder when I place it on the schematic it does not show the connection pins for power and ground (8 & 4 in this case) so when it is switched to the board layout you have to lay in the lines with the wire function -  In the library where you choose the part it shows the pin 8 and 4 connections but not when placed on the palette.

I also found this using the tubes library from eagle for 12A_7 type tubes - In the library it shows the heater connections but when it is placed on the schematic page the symbols for the heaters never show up.

I have been using Eagle for a while now and I noticed but never really questioned these funny little quirks and just make the compensations on the board manually.

Does anyone else notice this?

[screechingowl]

To get the power and gnd pins to show up on the schematic, you have to use the "invoke" command. Not sure about the tubes.

[defaced]

I think its the same with the tubes. I know I've used them before and definitely did a heater circuit, but im away on travel and don't have a computer to verify.

[Pigyboy]

Thanks you  guys.  I'll give it a go!!

Cheers,
Chris