Help me about DIY Tonebender MKII

[pumpkinpie]

I was doing Tonebender MKII, but there are some that I suspect the map circuit.
1. The map electrical circuits, how to put the switch (I used a DPDT switch 6 Pin and I do not use PCB).
2. on the top right of the map cycle (O-9v) I do not know what it is.
http://www.tonepad.com/project.asp?id=41 in layout ช่วยบอกฉันด้วย

[LucifersTrip]

I was doing Tonebender MKII, but there are some that I suspect the map circuit.
1. The map electrical circuits, how to put the switch (I used a DPDT switch 6 Pin and I do not use PCB).

look thru & find one that is good for you
http://tinyurl.com/nzhxy9e

2. on the top right of the map cycle (O-9v) I do not know what it is.

It is -9v

the "O" is part of the diagram

[pumpkinpie]

Your advice helped me a lot. But the second question (O-9v) Can you tell me more as to how I should do it.

[LucifersTrip]

There's nothing to do....the -9V shows where you connect the "-" of the battery

There is no "0". It is just the end of the line on the schematic signifying -9v

[pumpkinpie]

[pumpkinpie]

Map circuits I have to let the wires sticking out. Then close the filling in of the wire or not. (Figure 1 to Figure 2).

[duck_arse]

the line ending with a circle and -9V on the circuit diagram is only an imaginary wire. it does not exist in the real circuit board, but is an aid to reading the circuit diagram. there will be no actual wire needing to be taped, sticking out, or filled.

and can I say welcome to the forum, and here's something we don't see every day around here .....

.....  in layout ช่วยบอกฉันด้วย

[pumpkinpie]

Thanks LucifersTrip and duck_arse to help guide it helped me a lot.