Molten Voltage Delaytion on Vero

[Senor Avocado]

Hey everyone, this is my first time posting my own layout so hopefully it is good! I posted this over on the tagboard forum, but i hadn't had much of a response.

First off, Here are the links to the build document, and then a picture and link to the schematic for the delaytion.

http://www.moltenvoltage.com/pedalsync/Delaytion_PedalSync_MV-64_Analog_Delay_Control_Station_Project_Hack_DIY_by_Molten_Voltage.html

http://www.moltenvoltage.com/pedalsync/photos/delaytion/Delaytion_schematic_-_v1.jpg



I was fortunate enough to snag a MXR Carbon Copy Delay for very cheap on craigslist and I explored online to see if there were any mods for it. I stumbled upon the Delaytion, which on Molten Voltage's website says is an easy-to-use analog delay control station, featuring tap tempo, modulation, and four program storage. I was tickled pink to find this build document page to make one myself, but as i do not know how to etch circuit boards yet, i really wanted to try and make a stripboard layout for it. I was also ecstatic to see that smallbear sells the special molten voltage chips that are at the heart of this pedal. Here are those links.

http://smallbear-electronics.mybigcommerce.com/ic-mv-59/

http://smallbear-electronics.mybigcommerce.com/ic-mv-64/

I was hoping that this great community could look over my layout and see if there was anything that i may have missed! I am really excited to rehouse the Carbon Copy into a bigger enclosure with all this inside of it.

[archaos]

Did you eventually manage to get it working properly ?

[Senor Avocado]

Unfortunately I have not yet bought the chips or had time to work on this yet. Whenever I do i will for sure post about my experiences and progress!