AMZ FX ANALOG ALCHEMY GEOFX MEF ROG MEF DIY WIKI

Millennium C Bypass Question.

Started by Chugs, January 31, 2018, 04:45:05 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Chugs

January 31, 2018, 04:45:05 AM
I am interested in trying out the 4007 version of Millennium C bypass. Where does the connection to connect FX input to ground in bypass go? It is marked on the transistor version of the schematic but not on the 4007 version.

anotherjim

#1
January 31, 2018, 05:24:27 AM
If it's doing the same job as the discrete version, it must be the arrow leaving the .001 cap. Not sure why the cap value is different than the 0.1uF shown for the discrete version. I suspect a typo. Probably should be 0.1uF.

antonis

#2
January 31, 2018, 05:37:04 AM
Quote from: anotherjim on January 31, 2018, 05:24:27 AM
I suspect a typo.
I suspect you blame R.G. for blunder...  :icon_redface:
"I'm getting older while being taught all the time" Solon the Athenian..
"I don't mind  being taught all the time but I do mind a lot getting old" Antonis the Thessalonian..

Chugs

#3
February 01, 2018, 03:37:56 AM
Quote from: anotherjim on January 31, 2018, 05:24:27 AM
If it's doing the same job as the discrete version, it must be the arrow leaving the .001 cap. Not sure why the cap value is different than the 0.1uF shown for the discrete version. I suspect a typo. Probably should be 0.1uF.

Ok, that makes sense. Perhaps RG can chime in about the cap value?
Print
Go Up Pages1
User actions