Eagle Schematic/PCB Problem - Parametric EQ

[rdoucette858]

I am new to Eagle and pcb layouts in general and I am trying to add a jumper to make this last connection before going through and cleaning things up. No matter where I place the jumper in the schematic, it wants to jump the cap and resistor. I did the same thing for the L-Q pot and it worked fine.

Anyone have any tips or tricks to help this poor, downtrodden pedal builder?

[GGBB]

I don't see any connections to the jumper pins in your schematic. Try connecting them and see what happens.

[rdoucette858]

I don't see any connections to the jumper pins in your schematic. Try connecting them and see what happens.

I am not so dense that I wouldn't connect the jumper. I tested it in every conceivable position, even to the point that where I started placing them no longer made sense.

I managed to figure it out. I just placed 2 vias and finished the route on the top side of the board. Completes the circuit. No muss, no fuss.

[italianguy63]

I don't see any connections to the jumper pins in your schematic. Try connecting them and see what happens.

I am not so dense that I wouldn't connect the jumper. I tested it in every conceivable position, even to the point that where I started placing them no longer made sense.

I managed to figure it out. I just placed 2 vias and finished the route on the top side of the board. Completes the circuit. No muss, no fuss.

Yeah-- I recall having to do that.  And I just drew in the line (silk screen layer) to make it look like a jumper.

MC

[DIY Bass]

I have done it before by placing a zero ohm resistor (just place a resistor and make the value 0 ohm).

[GGBB]

I am not so dense that I wouldn't connect the jumper.

Hmm. Strange that it wouldn't show up on the schematic.