Hollis Easyvibe

[jpb_guitars]

Had problems finishing my Easyvibe a few days ago.
Today I found a mistake on the board and fixed it. (Missing connenction while drawing it in Illustrator) I used LDR's with light resistance 75 - 300 at 1000 lx and dark resistance at 10 M after 10 minutes and only 1 Euro each.
Now it works and sounds fantastic!!!
Great Pedal!!! Great Project!!!


Any ideas on mods out there!

Greetings from Germany,
Jan

[MarkB]

Congrads!
I finished my EasyVibe a few weeks ago - about to box it up..  it's a really great sounding circuit.

if you hook up your status LED to ground (through your switch) and take the + feed from right after the trimpot, it'll pulse in time with the LFO.
"-)

[MartyB]

Way to hang in there Jan!  Satisfying!  Do ya hear some Jimi comin outta that thang?

[KlausSp]

Hi Jan!

Where in Germany did you order your LDRs? I´ve tried to build the Easyvibe two times now, it did never work  :cry:

Schöne Grüße,

Klaus

[Thomas P.]

I'm looking forward to build it soon (lot's of pedals to build :wink: )
Therefor I bought a broken Crybaby (which wasn't broken) I will use as enclosure to get a little Univibe feel...

Anyway...nice to see some other german guys around here (Ich gehe zur Uni in Karlsruhe).

[jpb_guitars]

Good morning everyone,

yeah, there comes a little Jimi out of it!
Thanks for the tip with the pulsing LED. I will try that.

Hallo Klaus,
I've bought them at Conrad

Best.-Nr.: 14 54 75-33 Typ A 9060  Seite 995

[KlausSp]

Hi!

So I think I´ll have to place my next Conrad order soon

Btw, feel free to visit my page, it contains some information on DIY for german speaking builder.

Greetings,

Klaus

[jpb_guitars]

Hallo Klaus,

hab eben schon mal auf deiner Site vorbeigeschaut.

Ciao
jan