Love Clone Brown Source Help

[scotsman]

Greetings - I'm embarking on the "construction" of a Love Clone Brown Source and need a little help.  For the life of me I cannot tell how to wire the pots correctly.  Lug 2 is obvious - I really want to get this right the first time - and not have to resolder.  Could someone please tell me which pads are for Lug 1? 

My pots are facing with the solder tabs down - lug one is on the left.

Scematic and PCB layout at:

http://www.esnips.com/doc/94528c01-c4d1-47a0-a093-8740996b081c/Loveclone-Brown-source.pdf

Thanks in advance.

[scotsman]

I got it - feel free to delete this topic!

[scotsman]

I got it - feel free to delete this topic!

I got it "fired up" very late last night - wasn't able to give it a proper blessing until a bit ago.  It has a strange buzzyness to it - almost gated.  I've gone through the board all the components are in their right place.  I did notice if I touch the solder pads with my finger on the side of the op amp near the 22k resistor it seems to "clean up."  Possible cold joint or what? 

Oh - I'm using a 4558 in this.

Any help is greatly appreciated.