Sub Caster anyone?

[frequencycentral]

Hey everyone - do me a favour and just let this particular thread die - no more replies please - I sound like such a newb/dork on page 1 !

   So where should we post subcaster updates?

Hehehe - nah keep this thread going then!

[frequencycentral]

Here's the results of experiments I have performed on how to power 6111 heaters:

[Jered]

  Check out page 4 of this datasheet
http://www.mif.pg.gda.pl/homepages/frank/sheets/009/6/6021.pdf
   6.0 and 6.6 are absolute min/max heater voltages. Your right on the border of shortening the life of your tubes. 6.3 volts for filaments is best when possible.
  This pdf is for 6021's, but applies to 6111 and 6112 as far as heater voltage is concerned.

[frequencycentral]

  Check out page 4 of this datasheet
http://www.mif.pg.gda.pl/homepages/frank/sheets/009/6/6021.pdf
   6.0 and 6.6 are absolute min/max heater voltages. Your right on the border of shortening the life of your tubes. 6.3 volts for filaments is best when possible.
  This pdf is for 6021's, but applies to 6111 and 6112 as far as heater voltage is concerned.

I happily within tolerance! If it drops to 5.99 I'll start to worry.............