GGG Fuzz Face and Rangemaster and Small Bear

[mattpas]

Hey all,
I just ordered a Fuzz Face and Rangemaster PCB from General Guitar Gadgets and the GE Transistors from Smallbear.
Smallbear sends out resistors with the GE Transistors that are recommended to use.
The problem is, I don't know which ones to swap out.
Has anyone done this?

Rangemaster Layout:
http://www.generalguitargadgets.com/diagrams/geb_rm_lo_pp.gif
Smallbear resistors:
56k
3.9k

Fuzz Face:
http://www.generalguitargadgets.com/pdf/ggg_ff5_lo_pnp.pdf
Smallbear resistors:
30k
680ohms
9.1k
120k

[Dragonfly]

Hey all,
I just ordered a Fuzz Face and Rangemaster PCB from General Guitar Gadgets and the GE Transistors from Smallbear.
Smallbear sends out resistors with the GE Transistors that are recommended to use.
The problem is, I don't know which ones to swap out.
Has anyone done this?

Rangemaster Layout:
http://www.generalguitargadgets.com/diagrams/geb_rm_lo_pp.gif
Smallbear resistors:
56k
3.9k

The 56k will replace the 68k (R2)

The 3k9 is already on the layout.

Fuzz Face:
http://www.generalguitargadgets.com/pdf/ggg_ff5_lo_pnp.pdf
Smallbear resistors:
30k
680ohms
9.1k
120k

The 30k replaces the 33k (R2)

The 680 ohm replaces the 470 ohm (R4)

The 120k replaces the 100k (R3)

The 9k1 wont need to be used, as you have a 10k trimmer.

[mattpas]

Thanks for the help

[kurtlives]

Replace the 68K resistor on the RM with a 100K trim pot. Bias the transistor to your taste.