AMZ FX ANALOG ALCHEMY GEOFX MEF ROG MEF DIY WIKI

Red/Yellow Fasel pain in my WAH!

Started by Govmnt_Lacky, August 15, 2010, 01:00:10 PM

Previous topic - Next topic
Print
Go Down Pages 1 2
User actions

Govmnt_Lacky

#20
August 22, 2010, 09:22:06 AM
Well... The NEW Yellow Fasel works like a champ. Fired it up last night and it sounded sweet. Now I just have to find a good way to tune it. Prefferably by oscope.

I guess the old Yellow was just bad internally. It ohmed out at 23 ohms (The new one read 17) but would not Wah. Could have been a cold solder joint too.
A Veteran is someone who, at one point in his or her life, wrote a blank check made payable to The United States of America
for an amount of 'up to and including my life.'

tubelectron

#21
August 22, 2010, 10:23:24 AM
Hi,

QuoteCould have been a cold solder joint too.

I may be wrong, but I think that it was probably the issue, as 23 ohm would not be suspicious for a wah coil. So don't throw it...

A+!
I apologize for my approximative english writing and understanding !
http://guilhemamplification.jimdofree.com/

Govmnt_Lacky

#22
August 22, 2010, 11:31:23 AM
Quote from: tubelectron on August 22, 2010, 10:23:24 AM
So don't throw it...

Believe me... I don't throw anything out unless it has released the magic smoke!  :icon_lol:
A Veteran is someone who, at one point in his or her life, wrote a blank check made payable to The United States of America
for an amount of 'up to and including my life.'

Paul Marossy

#23
August 22, 2010, 07:47:07 PM
Quote from: Govmnt_Lacky on August 22, 2010, 09:22:06 AM
Could have been a cold solder joint too.

The easy way to figure that out is to just reflow the suspected solder joints. I've had solder joints that looked like they should be fantastic but actually were cold solder joints. Looks can be deceiving.
Print
Go Up Pages 1 2
User actions