MXR Dist+ Vero layout Q

[rage1981]

Been following this,

LINK

I finally got all the parts soldered in the right place, now when it comes to finishing it off with jacks, battery and pots, I've gotten myself a little lost, as I don't want a LED or Switch, so the distortion will always be on.

If anyone can help with where wires should go it'd be a great help, as I'm aslo struggling to find the ground too.

TIA

[rage1981]

Think what I'm asking is:

Where's the board input, output and ground.

[aron]

Input is the 1M resistor on the left - purple trace - that's the input. Ground is the green on the left. So one lead of the 1M is the input (purple), the other lead is the ground (green). The output is the middle (wiper) of the 10K vol pot.

[rage1981]

Thank you very much.